Rohde & Schwarz RTE - Search Results

Remote control commands
R&S
®
RTE
1667User Manual 1326.1032.02 ─ 20
SEARch:TRIGger:ETHernet:ERRor:SELect <SearchName>,<ErrorCondition>
SEARch:TRIGger:ETHernet:ERRor:SELect? <SearchName>
Defines, whether a search for an error condition shall be activated or not.
Parameters:
<ErrorCondition> ON | OFF
*RST: OFF
Parameters for setting and query:
<SearchName> String parameter
SEARch:TRIGger:ETHernet:ERRor:PREamble
<SearchName>,<ErrorPreamble>
SEARch:TRIGger:ETHernet:ERRor:PREamble? <SearchName>
Defines, whether a search for any preamble error shall be activated or not.
Parameters:
<ErrorPreamble> ON | OFF
*RST: ON
Parameters for setting and query:
<SearchName> String parameter
SEARch:TRIGger:ETHernet:ERRor:LENGth <SearchName>,<ErrorLength>
SEARch:TRIGger:ETHernet:ERRor:LENGth? <SearchName>
Defines, whether a search for any word length error (too few or too many bits per word)
shall be activated or not.
Parameters:
<ErrorLength> ON | OFF
*RST: ON
Parameters for setting and query:
<SearchName> String parameter
18.17.12.5 Search results
To show the results on the screen, use the following commands:
●
BUS<m>:RESult on page 1421
In all SEARch:RESult:ETHernet:WORD<m> commands, the suffix <m> selects the
word number in the list of search results.
SEARch:RESult:ETHernet:WCOunt?............................................................................. 1668
SEARch:RESult:ETHernet:WORD<m>:STATe?...............................................................1668
SEARch:RESult:ETHernet:WORD<m>:STARt?...............................................................1668
SEARch:RESult:ETHernet:WORD<m>:STOP?............................................................... 1669
SEARch:RESult:ETHernet:WORD<m>:DESTaddress?.................................................... 1669
SEARch:RESult:ETHernet:WORD<m>:SRCaddress?......................................................1669
Protocols