Rohde & Schwarz RTE - Function Generator

Remote control commands
R&S
®
RTE
1924User Manual 1326.1032.02 ─ 20
Suffix:
<m>
.
1..2
Usage: Event
18.19.1.2 Function generator
WGENerator<m>:FUNCtion[:SELect].............................................................................1924
WGENerator<m>:FREQuency.......................................................................................1924
WGENerator<m>:PERiod............................................................................................. 1924
WGENerator<m>:FUNCtion:PULSe[:WIDTh].................................................................. 1925
WGENerator<m>:FUNCtion:RAMP[:SYMMetry]..............................................................1925
WGENerator<m>:FUNCtion:SQUare:DCYCle.................................................................1925
WGENerator<m>:FUNCtion[:SELect] <FunctionType>
Sets the type of waveform to be generated for the function generator.
Suffix:
<m>
.
1..2
Parameters:
<FunctionType> SINusoid | SQUare | RAMP | DC | PULSe | SINC | CARDiac |
GAUSs | LORNtz | EXPRise | EXPFall
SINC: Cardial sine
*RST: SINusoid
WGENerator<m>:FREQuency <Frequency>
Sets the frequency of the waveform. The available frequency range depends on the
selected function type.
Suffix:
<m>
.
1..2
Parameters:
<Frequency> Range: 1E-3 to 100E+6
Increment: 1
*RST: 1E+6
Default unit: Hz
WGENerator<m>:PERiod <Period>
Sets the period of the waveform. The available period range depends on the selected
function type.
Suffix:
<m>
.
1..2
Waveform generator (option R&S RTE-B6)