Rohde & Schwarz RTE - Math Setup - General Settings

Waveform analysis
R&S
®
RTE
296User Manual 1326.1032.02 ─ 20
5. Enter the "Vertical scale" factor (per division). If necessary, add a "Vertical offset".
By default the instrument performs an automatic scaling.
Tip: You can also use the vertical [SCALE] rotary knob for scaling. In this case, the
scale mode is set to "Manual" temporarily.
6. If you need the envelope or average of the math waveform over several calcula-
tions, change the arithmetic mode for the waveform as for channel waveforms.
See also: "Arithmetic" on page 182.
7. Close the "Math Setup" dialog box.
7.3.2 Math setup - general settings
You can define up to eight different math waveforms. Each waveform is defined in a
separate tab in the "Math" dialog box ("M1" to "M8").
The settings for input of mathematical formulas in basic and advanced editors are
described in separate chapters:
●
Chapter 7.3.3.1, "Settings in the Basic editor", on page 299
●
Chapter 7.3.4, "Advanced", on page 301
The general settings for enabling, scaling and waveform arithmetic are:
Enable math signal......................................................................................................297
Vertical Scale.............................................................................................................. 297
└ Vertical scaling mode (Manual/Auto)............................................................ 297
└ Vertical Scale................................................................................................ 297
└ Vertical Offset................................................................................................297
Arithmetic.................................................................................................................... 297
Mathematics