Rohde & Schwarz RTE - LIN (Option R&S RTE-K3)

Protocol analysis
R&S
®
RTE
599User Manual 1326.1032.02 ─ 20
Figure 13-29: Search results table and search zoom window. Search for signal "IdleRunning" with
value "Running" (bit value = 0)
The figure shows the result of a search for an "EngineData" message and the signal
"IdleRunning = Running" inside the message. The result marker (blue line) is set to the
start of the frame that fulfills the search condition. The search zoom window Search1 is
active. It has been moved to the right until the "IdleRunning" bit with value 0 is visible in
the zoom.
Remote command:
●
SEARch:RESult:CAN:FRAMe<m>:SDATa? on page 1527
13.6 LIN (option R&S RTE-K3)
The Local Interconnect Network (LIN) is a simple, low-cost bus system used within
automotive network architectures. LIN is usually a subnetwork of a CAN bus. The pri-
mary purpose of LIN is the integration of uncritical sensors and actuators with low-
bandwidth requirements. Common applications in a motor vehicle are the control of
doors, windows, wing mirrors, and wipers.
LIN (option R&S
RTE-K3)