Protocol analysis
R&S
®
RTE
661User Manual 1326.1032.02 ─ 20
13.9.2 MIL-STD-1553 configuration
13.9.2.1 MIL-STD-1553 configuration settings
Access: [PROTOCOL] > "Decode" tab > "Protocol" = MIL-STD-1553
Make sure that the tab of the correct serial bus is selected on the left side.
See also: Chapter 13.1.1, "Decode - general settings", on page 514.
Source
Sets the source of the selected data line. Analog channels, math waveforms, and refer-
ence waveforms can be used.
For triggering on a serial bus, a channel signal is required.
Remote command:
BUS<m>:MILStd:SOURce on page 1607
Polarity
Selects the wire on which the bus signal is measured : "Normal" or "Inverted". The set-
ting affects the digitization of the signal.
Remote command:
BUS<m>:MILStd:POLarity on page 1608
MIL-1553 (option R&S
RTE-K6)
To Next Page
Loading...
