Power analysis (option R&S RTE-K31)
R&S
®
RTE
1000User Manual 1326.1032.02 ─ 20
Steady state level- Turn off ← Turn off
Sets the percentage of the steady state level of the DC output that has to be reached.
Remote command:
POWer:ONOFf:DSOFf on page 1966
Trigger level ← Turn off
Triggers the beginning of the measurements at the moment the AC or DC input voltage
reaches the set value.
Remote command:
POWer:ONOFf:ATOFf on page 1966
POWer:ONOFf:DTOFf on page 1966
Time ← Turn off
Sets the time, the start of the measurement of the turn off time is delayed with, after
the trigger point.
Remote command:
POWer:ONOFf:TIME on page 1967
Report comment
In this field you can write a comment that is displayed in the measurement report, for
example, a measurement description.
Execute
Starts the " Power Quality" measurement.
Remote command:
POWer:ONOFf:EXECute on page 1966
16.5.3 Switching loss
The "Switching Loss" analysis measures the power and energy losses of a switching
device, that occur during the switching phases and the conduction phase of the switch-
ing transistor.
Required probes:
●
Differential voltage probe
●
Current probe
16.5.3.1 Switching loss results
The results of "Switching Loss" measurements are provided in two ways:
●
The diagram shows the graphical presentation of:
– the voltage waveform
– the current waveform
– the power waveform
Power path
To Next Page
Loading...
