Measurements
R&S
®
RTE
382User Manual 1326.1032.02 ─ 20
"Frame"
Selects the type of frame.
"Field"
Selects the type of field.
"Value"
Sets a value for the selected field.
Remote command:
MEASurement<m>:PROTocol:MBITrate:FLD on page 1299
MEASurement<m>:PROTocol:MBITrate:FRM on page 1299
MEASurement<m>:PROTocol:MBITrate:VAL on page 1299
MEASurement<m>:PROTocol:SBITrate:FLD on page 1299
MEASurement<m>:PROTocol:SBITrate:FRM on page 1299
MEASurement<m>:PROTocol:SBITrate:VAL on page 1300
8.2.10 Result analysis
The behavior of measurement results over time can be evaluated in different ways:
●
Statistics
●
Long-term measurements
●
Histograms on measurement results
●
Track
8.2.10.1 Statistics
Statistics are compiled for all measurements. If enabled, statistical results of all active
measurements are shown in the result box.
By default, all events in each acquisition are measured and incuded in the statitics: the
measurement result is not only determined once within one acquisition, but repeatedly,
if available. More results provide a larger basis for statistical evaluation.
To obtain precise results, additional measurement settings can be useful:
●
Reference/signal levels: configuring user-defined levels can compensate for irregu-
lar data, see Chapter 8.2.4, "Reference levels", on page 344.
Automatic measurements
To Next Page
Loading...
