Measurements
R&S
®
RTE
327User Manual 1326.1032.02 ─ 20
8.1.3.1 Setup tab
Access: [CURSOR] key > "Setup" tab
The "Setup" tab contains the settings for cursor measurements.
Figure 8-3: Setup for cursor on 1 source
Figure 8-4: Setup for cursor on 2 sources
Cursor set (vertical tabs)
The settings for each cursor measurement (or cursor set) are configured on separate
tabs. For each cursor set, a horizontal pair of cursors, a vertical pair of cursors, or both
can be displayed.
Enable
Enables the selected cursor measurement.
Remote command:
CURSor<m>:STATe on page 1239
Cursor measurements
To Next Page
Loading...
