Rohde & Schwarz RTE - Page 1239

Remote control commands
R&S
®
RTE
1239User Manual 1326.1032.02 ─ 20
CURSor<m>:YCOupling............................................................................................... 1243
CURSor<m>:X1ENvelope.............................................................................................1243
CURSor<m>:X2ENvelope.............................................................................................1244
CURSor<m>:STYLe.....................................................................................................1244
CURSor<m>:LABel...................................................................................................... 1245
CURSor<m>:SIAD....................................................................................................... 1245
CURSor<m>:STATe <State>
Switches the indicated cursor on or off.
Suffix:
<m>
.
1 | 2
Selects the cursor set.
Parameters:
<State> ON | OFF
*RST: OFF
Usage: Asynchronous command
CURSor<m>:AOFF
This command switches all cursors off.
Suffix:
<m>
.
The numeric suffix is irrelevant.
Usage: Event
Asynchronous command
CURSor<m>:FUNCtion <Type>
Defines the type of the indicated cursor set.
Suffix:
<m>
.
1 | 2
Selects the cursor set.
Parameters:
<Type> HORizontal | VERTical | PAIRed
HORizontal
A pair of horizontal cursor lines.
VERTical
A pair of vertical cursor lines.
PAIRed
Both vertical and horizontal cursor line pairs.
*RST: PAIRed
Usage: Asynchronous command
Cursor measurements