Protocol analysis
R&S
®
RTE
890User Manual 1326.1032.02 ─ 20
5. Tap "Trigger Type" and select the trigger type to be used for CXPI protocol analy-
sis.
6. Depending on the selected trigger type, more setup conditions can be specified.
For information on how to proceed with the configuration settings, see Chap-
ter 13.19.3.1, "CXPI trigger settings", on page 882.
13.19.4 Search on decoded CXPI data
Using the search functionality, you can find various events in the decoded data, the
same events which you also can trigger on. Before you can start the search, you have
to configure the bus correctly and acquire decoded data.
To search on decoded data, set the search "Source" to the serial bus that is configured
for the protocol to be analyzed.
See also Chapter 11, "Search functions", on page 445.
13.19.4.1 Search settings
Access: [SEARCH] > "Setup" tab
Search type
Selects the condition type for the CXPI search.
"Frame Start"
Searches for a frame start.
CXPI (option R&S RTE-K76)
To Next Page
Loading...
