Data and file management
R&S
®
RTE
492User Manual 1326.1032.02 ─ 20
Remote command:
EXPort:HISTogram:NAME on page 1408
EXPort:HISTogram:SAVE on page 1408
EXPort:HISTogram:DATA? on page 1408
Histogram source, Horizontal range, Vertical range
Show the source and the limits of the histogram area for information.
The ranges are set in the "Histogram" dialog box ("Meas" menu > "Histogram").
See also: Chapter 8.2.8.4, "Histogram setup", on page 373.
12.2.4 Numeric Results
In this tab, you can select the result boxes to be saved, and define the storage set-
tings.
Access: [FILE] > "Numeric Results"
Access to the tab is available in all tabs where measurement and analysis settings are
defined, for example, in the "Measurements Setup", "Cursors Setup", and "Masks Test
Definition" tabs: Simply tap the "Result Export" button.
Furthermore, you can export the decode result tables of serial protocol analysis.
Result selection
The table lists all result boxes and decode tables that are currently open, including
minimized boxes and docked boxes. Select the results that you want to save to file. All
results are written into one file.
Waveform data and results
To Next Page
Loading...
