Rohde & Schwarz RTE - Performing and Configuring the Quick Measurement

Getting started
R&S
®
RTE
89User Manual 1326.1032.02 ─ 20
11. Close the "Measurements" dialog box and check the results.
12. To see all results, drag up the border of the results tab.
13. Close the "Measurement Results" box.
3.3.6.3 Performing and configuring the quick measurement
A set of up to eight different measurements on one source can be performed at once,
simply by tapping the "Quick measurement" toolbar icon. The results are displayed in a
result box. You can configure the measurement types to be included in quick measure-
ment. This way, repeating measurements are performed very quickly.
In the following example, you start a quick measurement and change the QuickMeas
configuration.
1. Press [AUTOSET].
2. Tap the "Quick measurement" icon on the toolbar.
3. Tap the diagram.
The result box shows the results of the default quick measurement.
Trying out the instrument