Rohde & Schwarz RTE - Displaying an XY-Diagram

Waveform analysis
R&S
®
RTE
320User Manual 1326.1032.02 ─ 20
Remote command:
WAVeform<m>:XYCurve:YSOurce on page 1237
Constant XY-ratio
If enabled, the x- and y-axes maintain a constant ratio in the diagram.
Remote command:
WAVeform<m>:XYCurve:RATio on page 1236
Swap XY
Replaces the source of the x-axis with the source of the y-axis and vice versa.
Remote command:
WAVeform<m>:XYCurve:SWAP on page 1236
7.5.2 Displaying an XY-diagram
You can create the diagram from active waveforms with drag&drop, or use the dialog
box for setup.
To display an XY-diagram with drag&drop
Prerequisites: The source waveform for the y-axis is active in a diagram, the source
waveform for the x-axis is either active or minimized.
1. Drag the x-axis waveform to the lower left corner of the diagram with the y-axis
waveform.
2. Drop the icon when it overlaps the left and lower diagram borders.
The diagram is converted into an XY-diagram.
XY-diagram