Rohde & Schwarz RTE - LIN Trigger; LIN Trigger Settings

Protocol analysis
R&S
®
RTE
604User Manual 1326.1032.02 ─ 20
6. Set the logical thresholds.
Either according to technology definition with "Preset thresholds", or to an auto-
matic value with "Full autoset"/ "Auto thresholds", or enter a user-defined value
directly in the "Threshold" fields.
7. Set the "LIN standard", "Bit rate" and "Polarity" according to your signal.
8. Enable "Decode".
13.6.3 LIN trigger
13.6.3.1 LIN trigger settings
Access: [PROTOCOL] > "Trigger" tab > "Source = Serial Bus"
Make sure that:
●
In the [PROTOCOL] > "Decode" tab:
– The correct "Protocol" is selected.
– The data sources of the serial bus are channel signals.
●
In the "Trigger" > "Setup" tab:
– The trigger "Sequence" = "A only".
– The trigger "Source" = "Serial bus".
– The correct "Serial bus" is selected.
LIN (option R&S
RTE-K3)