Remote control commands
R&S
®
RTE
1210User Manual 1326.1032.02 ─ 20
Suffix:
<m>
.
1..3
The suffix is irrelevant.
Parameters:
<RunExecutable> NOACtion | TRIGger
*RST: NOACtion
Usage: Asynchronous command
18.9.21 External trigger input
To control the external trigger signal, the TRPRobe commands are used. The required
commands depend on the used probe type. They work in the same way as the PROBe
commands. For details, see Chapter 18.8.7, "Probes", on page 1123
TRIGger<m>:EXTern:OVERload <Overload>
The query returns the overload status of the external trigger input.
:TRIGger:EXTern:OVERload 0 confirms the information in the message box, it has
same effect as OK.
Suffix:
<m>
.
1..3
Only 1 = A-trigger, 2 | 3 = not available. Can be omitted.
Parameters:
<Overload> ON | OFF
ON | 1
Iindicates an overload of the probe
OFF | 0
In a query: no overlaod.
Ssetting: confirms the information in the message box
*RST: OFF
Usage: Asynchronous command
18.9.22 Acquisition info
ACQuire:CURRent?
Shows the current number of acquisitions that have been acquired.
Return values:
<CurrAcqCnt> Range: 0 to 4294967295
Increment: 1
*RST: 0
Usage: Query only
Asynchronous command
Trigger
To Next Page
Loading...
