Rohde & Schwarz RTE - Reference; Reference Waveforms

Remote control commands
R&S
®
RTE
1220User Manual 1326.1032.02 ─ 20
Parameters for setting and query:
<DiagramName> Name of the diagram on which the zoom area is based.
<ZoomName> Name of the zoom diagram
Usage: Asynchronous command
LAYout:ZOOM:REMove <DiagramName>, <ZoomName>
Removes the specified zoom diagram.
Setting parameters:
<DiagramName> Name of the diagram on which the zoom area is based.
<ZoomName> Name of the zoom diagram
Example: See Chapter 18.3.1.2, "Creating zoom diagrams", on page 1056
Usage: Setting only
Asynchronous command
18.10.2 Reference waveforms
● Reference............................................................................................................1220
● Scaling................................................................................................................ 1222
● Waveform data export.........................................................................................1224
● Import of multichannel waveform data................................................................ 1225
18.10.2.1 Reference
REFCurve<m>:SOURce...............................................................................................1220
REFCurve<m>:STATe...................................................................................................1221
REFCurve<m>:NAME.................................................................................................. 1221
REFCurve<m>:OPEN...................................................................................................1221
REFCurve<m>:UPDate................................................................................................ 1222
REFCurve<m>:SAVE................................................................................................... 1222
REFCurve<m>:DELete.................................................................................................1222
REFCurve<m>:CLEar...................................................................................................1222
REFCurve<m>:SOURce <Source>
Selects the source waveform to be used as a reference.
Suffix:
<m>
.
1..4
Reference waveform
Waveform analysis