Data and file management
R&S
®
RTE
473User Manual 1326.1032.02 ─ 20
Load from file
Enter the file name to load the setting data from, and select the file format with the for-
mat button on the right. Double-tap the file name to open the file selection dialog box.
See also: Chapter 12.7, "File selection dialog", on page 511.
By default, saveset file names have the prefix "Settings_".
"Open"
Opens a file selection dialog box and loads the selected file.
Remote command:
MMEMory:RCL on page 1396
12.1.2 One File
The One File function stores the savesets file and the data of active reference wave-
forms together in a ZIP file. If you want to keep channel waveform data together with
the instrument settings, make sure to create a reference waveform from the channel
waveform before you save the One File.
The waveform generator/pattern generator and the pulse source state is saved as
"Off".
12.1.2.1 Save One File settings
Access: [FILE] key > "Save" tab > "One File"
Save to file
Enter the file name to save the One File data to, and select the file format with the for-
mat button on the right. Double-tap the file name to open the file selection dialog box.
See also: Chapter 12.7, "File selection dialog", on page 511.
By default, one file names have the prefix "OneFile_".
"Save"
Saves the data to the selected file.
"Save As..."
Opens the file selection dialog box and saves the data to the selected
file.
".zip"
Shows the file format.
Remote command:
SAVeset:ONEFile:NAME on page 1397
SAVeset:ONEFile:SAVE on page 1398
Save and recall user settings
To Next Page
Loading...
