Protocol analysis
R&S
®
RTE
644User Manual 1326.1032.02 ─ 20
13.8.2.2 Configuring audio protocol
The configuration of the Audio is simple - assign the two lines to input channels, and
set the thresholds.
For details on configuration settings, see Chapter 13.8.2.1, "Audio signal configura-
tion", on page 639.
1. Press the [PROTOCOL] key on the front panel.
2. Select the tab of the bus you want to set up, for example "SB1".
3. Select the "Decode" tab.
4. Tap the "Protocol" button and select the protocol: "Audio".
5. Select the "Audio Variant".
6. Set the parameters, as required according to the selected "Audio Variant".
7. Enable "Decode", if available.
13.8.3 Audio trigger
13.8.3.1 Audio trigger
Access: [PROTOCOL] > "Trigger" tab > "Source = Serial Bus"
Audio signals (option R&S RTE-K5)
To Next Page
Loading...
