Protocol analysis
R&S
®
RTE
850User Manual 1326.1032.02 ─ 20
13.17.2 USBPD configuration
13.17.2.1 USBPD configuration settings
Access: [PROTOCOL] key > "Decode" tab > "Protocol" = "USBPD"
Make sure that the tab of the correct serial bus is selected.
See also: Chapter 13.1.1, "Decode - general settings", on page 514.
Data
Defines the source settings for the data signal. You can select analog channels "C1" to
"C4", and also active math and reference waveforms as source. If you want to trigger
on the serial bus, analog channel sources are required.
Remote command:
BUS<m>:USBPd:SOURce on page 1832
vData
Sets the threshold value of the data.
Remote command:
BUS<m>:USBPd:THReshold on page 1832
USBPD (option R&S
RTE-K63)
To Next Page
Loading...
