Rohde & Schwarz RTE - Configuring Slew Rate

Power analysis (option R&S RTE-K31)
R&S
®
RTE
989User Manual 1326.1032.02 ─ 20
●
"M2" Math 4 to calculate the time derivative of the current or voltage waveform
●
"C 1" Cursor 1 to determine the measurement area
The used resources are listed in the "Details" tab. See also: Chapter 16.2.3, "Details
tab", on page 966.
The following remote commands are used for handling the measurement results:
●
POWer:SLEWrate:RESult:ACTual? on page 1962
●
POWer:SLEWrate:RESult:AVG? on page 1962
●
POWer:SLEWrate:RESult:EVTCount? on page 1962
●
POWer:SLEWrate:RESult:NPEak? on page 1962
●
POWer:SLEWrate:RESult:PPEak? on page 1962
●
POWer:SLEWrate:RESult:RMS? on page 1962
●
POWer:SLEWrate:RESult:STDDev? on page 1963
●
POWer:SLEWrate:RESult:WFMCount? on page 1963
●
POWer:SLEWrate:REPort:ADD on page 1962
16.4.3.2 Configuring slew rate
For details of the configuration settings, see Chapter 16.4.3.3, "Slew rate settings",
on page 990.
1. Select "Analysis" > "Power".
2. Under "Switching / Control Loop", select "Slew Rate".
3. Connect the differential voltage probe and the current probe to the oscilloscope.
4. Deskew the probes as described in Chapter 16.1.1.1, "Auto deskew", on page 955.
5. Connect the probes to the DUT as shown in the "Channels" tab:
Control loop