Rohde & Schwarz RTE - ARINC 429 Configuration; ARINC 429 Configuration Settings

Protocol analysis
R&S
®
RTE
679User Manual 1326.1032.02 ─ 20
13.10.2 ARINC 429 configuration
13.10.2.1 ARINC 429 configuration settings
Access: [PROTOCOL] > "Decode" tab > "Protocol" = ARINC 429
Make sure that the tab of the correct serial bus is selected.
See also: Chapter 13.1.1, "Decode - general settings", on page 514.
Data
Sets the source of the selected data line. Usually, the source is one of the analog
channels. Reference and math waveforms are only available if the trigger source is
one of the input channels but not the serial bus.
For triggering on a serial bus, a channel signal is required.
Remote command:
BUS<m>:ARINc:SOURce on page 1633
Polarity
Selects the wire on which the bus signal is measured : "A Leg" or "B Leg". The setting
affects the digitization of the signal.
Remote command:
BUS<m>:ARINc:POLarity on page 1634
ARINC 429 (option R&S
RTE-K7)