Rohde & Schwarz RTE - CAN and CAN FD Decode Results

Protocol analysis
R&S
®
RTE
580User Manual 1326.1032.02 ─ 20
29,01A54321h,Throttle
29,13A00FA2h,LightState
29,0630ABCDh,Engine_Status
29,03B1C002h,Airbag_Status
29,01234ABCh,NM_Gateway
# ----------------------------------------------------------------------------
For general information on the "Label List" tab, see
Chapter 13.1.4, "Label lists",
on page 517.
Remote command:
●
BUS<m>:CAN:FRAMe<n>:SYMBol? on page 1503
13.5.5 CAN and CAN FD decode results
When the configuration of the serial bus is complete, the signal can be decoded:
1. In the "Protocol" dialog > "Decode" tab, enable "Decode".
2. In the "Protocol" dialog > "Display" tab, select additional result display settings:
"Show decode table" and "Show binary signals".
For a description of the display settings, see also Chapter 13.1.3, "Display",
on page 515.
The instrument captures and decodes the signal according to the standard definition
and the configuration settings.
The color-coding of the various protocol sections and errors simplifies the interpretation
of the visual display. The decode information condenses or expands, depending on the
horizontal scale. Various data formats are available to show the result values.
CAN and CAN FD (option R&S
RTE-K3/K9)