Rohde & Schwarz RTE - Micro Button and R&S Probemeter

Remote control commands
R&S
®
RTE
1126User Manual 1326.1032.02 ─ 20
Suffix:
<m>
.
1..4
Selects the input channel.
Parameters:
<AutoZeroOffset> ON | OFF
*RST: OFF
Usage: Asynchronous command
Firmware/software: Version 2.70
CHANnel<m>:EATScale <ExtAttScl>
Sets the attenuation scale for an external divider.
Suffix:
<m>
.
1..4
Selects the input channel.
Parameters:
<ExtAttScl> LIN | LOG
*RST: LIN
Usage: Asynchronous command
CHANnel<m>:EATTenuation <ExtAtt>
Sets the attenuation of an external voltage divider that is part of the DUT before the
measuring point. The external attenuation is included in the measurement, and the
instrument shows the results that would be measured before the divider.
Suffix:
<m>
.
1..4
Selects the input channel.
Parameters:
<ExtAtt> Values and unit depend on the selected scale (CHANnel<m>:
EATScale).
Range: Linear scale: 1E-3 to 1E+6, logarithmic scale: -60
dB to 120 dB
Increment: 0.01
*RST: 1
Usage: Asynchronous command
18.8.7.2 Micro button and R&S ProbeMeter
PROBe<m>:SETup:MODE............................................................................................1127
TRPRobe:SETup:DISPlaydiff.........................................................................................1128
PROBe<m>:SETup:DISPlaydiff......................................................................................1128
TRPRobe:PMETer:VISibility...........................................................................................1128
Acquisition and setup