Rohde & Schwarz RTE - Holdoff; Line Trigger

Remote control commands
R&S
®
RTE
1197User Manual 1326.1032.02 ─ 20
18.9.15 Line trigger
To select the line trigger, set TRIGger<m>:SOURce[:SELect] to LINE.
TRIGger<m>:POWerline:SLOPe <Slope>
Selects the rising or falling edges of the AC power input for the trigger condition.
Suffix:
<m>
.
1..3
Only 1 = A-trigger, 2 | 3 = not available. Can be omitted.
Parameters:
<Slope> POSitive | NEGative
*RST: POSitive
Usage: Asynchronous command
18.9.16 Holdoff
TRIGger<m>:HOLDoff:MODE........................................................................................1197
TRIGger<m>:HOLDoff:TIME..........................................................................................1198
TRIGger<m>:HOLDoff:EVENts......................................................................................1198
TRIGger<m>:HOLDoff:MIN........................................................................................... 1199
TRIGger<m>:HOLDoff:MAX.......................................................................................... 1199
TRIGger<m>:HOLDoff:AUTotime?................................................................................. 1200
TRIGger<m>:HOLDoff:SCALing.................................................................................... 1200
TRIGger<m>:HOLDoff:MODE <Mode>
Selects the method to define the holdoff condition.
The trigger holdoff defines when the next trigger after the current will be recognized.
Thus, it affects the next trigger to occur after the current one. Holdoff helps to obtain
stable triggering when the oscilloscope is triggering on undesired events.
Suffix:
<m>
.
1..3
Only 1 = A-trigger, 2 | 3 = not available. Can be omitted.
Parameters:
<Mode> TIME | EVENts | RANDom | AUTO | OFF
TIME
Defines the holdoff directly as a time period. The next trigger
occurs only after the "Holdoff time" has passed (defined using
TRIGger<m>:HOLDoff:TIME).
EVENts
Defines the holdoff as a number of trigger events. The next trig-
ger occurs only when this number of events is reached. The
number of triggers to be skipped is defined using TRIGger<m>:
HOLDoff:EVENts.
Trigger