Rohde & Schwarz RTE - MDIO Search Setup; Search on Decoded MDIO Data

Protocol analysis
R&S
®
RTE
813User Manual 1326.1032.02 ─ 20
Data format
You can select various data formats for the values displayed in the decode table and in
the combs of the decoded signal.
Remote command:
●
BUS<m>:FORMat on page 1422
Export of decode results
1. In the protocol decode table, press "Export".
The "Numeric Results" dialog opens.
For details, see Chapter 12.2.4, "Numeric Results", on page 492.
2. Select the decode results you want to export, the file format, and the delimiter.
3. Tap "Save" or "Save as".
Remote commands
Remote commands to retrieve decode results are described in Chapter 18.17.16.3,
"Decode results", on page 1781.
13.15.6 Search on decoded MDIO data
Using the search functionality, you can find various events in the decoded data. You
can find the same events that you can trigger on, and even many more, since several
event types can also be combined.
Before you can start the search, you have to configure the bus correctly and acquire
decoded data.
To search on decoded data, set the search source to "SerBus" for the configured proto-
col.
For general information on how to handle the search functionality, see Chapter 11,
"Search functions", on page 445.
If you need information on how to get started with searching MDIO data, see Chap-
ter 13.15.6.3, "Searching MDIO data", on page 815. Otherwise proceed with the
MDIO search setup.
13.15.6.1 MDIO search setup
Access: [SEARCH] > "Setup" tab
Search types
Selects the event types to be searched.
MDIO (option R&S
RTE-K55)