Rohde & Schwarz RTE - Symbolic Search Results

Protocol analysis
R&S
®
RTE
598User Manual 1326.1032.02 ─ 20
Remote command:
SEARch:TRIGger:CAN:SYMBolic:SIGValue on page 1528
Condition
Sets the operator to set a specific data pattern or symbolic value ("Equal" or "Not
equal") or a data range.
This condition is also used to search for data, see "Data setup: DLC, NDB, Condition,
Data min, Data max" on page 588.
Remote command:
SEARch:TRIGger:CAN:DCONdition on page 1513
Value, Value (min)
Defines the data pattern or selects a symbolic data value.
Remote command:
SEARch:TRIGger:CAN:SYMBolic:DMIN on page 1528
SEARch:TRIGger:CAN:SYMBolic:SGEValue on page 1529
Value (max)
The second data pattern is required to specify a range with conditions "In range" and
"Out of range".
Remote command:
SEARch:TRIGger:CAN:SYMBolic:DMAX on page 1528
13.5.7.4 Symbolic search results
If a DBC file is applied, you can search for symbolic messages and signals as descri-
bed in Chapter 13.5.7.3, "Symbolic search", on page 596. As ususal, the search results
are shown in a table. You can enable the search zoom window to view the frame with
the selected result in more detail.
CAN and CAN FD (option R&S RTE-K3/K9)