Rohde & Schwarz RTE - Page 588

Protocol analysis
R&S
®
RTE
588User Manual 1326.1032.02 ─ 20
FD bits: see "FD bits" on page 588.
Remote command:
SEARch:TRIGger:CAN:ICONdition on page 1512
SEARch:TRIGger:CAN:IMIN on page 1513
SEARch:TRIGger:CAN:IMAX on page 1512
FD bits
For standard settings " CAN FD" and "Any", you can search for CAN FD-specific bits.
For details, see "FD bits" on page 570.
The setting is available in CAN FD option R&S RTE-K9.
Remote command:
SEARch:TRIGger:CAN:FDATa[:FDF] on page 1517
SEARch:TRIGger:CAN:FDATa:BRS on page 1517
SEARch:TRIGger:CAN:FDATa:ESI on page 1518
Data setup: DLC, NDB, Condition, Data min, Data max
The data setup consists of the number of bytes, the condition, and one or two data pat-
terns.
The data setup settings are the same as in the CAN trigger setup, see "Data setup:
DLC, NDB, Transfer, Condition, Data min, Data max" on page 570.
The data condition setting is also used for symbolic signal search, see Chap-
ter 13.5.7.3, "Symbolic search", on page 596.
Figure 13-24: Identifier + Data search setup for CAN signals
CAN and CAN FD (option R&S RTE-K3/K9)