Rohde & Schwarz RTE - Defining the Search Gate; Result Presentation; Result Presentation Settings

Search functions
R&S
®
RTE
463User Manual 1326.1032.02 ─ 20
If several cursor measurements are enabled, select the cursor set to be used for gat-
ing. The "Start" and "Stop" values of the gate are adjusted to the values of the cursor
line positions. The measurement is limited to the part of the waveform between the cur-
sor lines.
Remote command:
MEASurement<m>:GATE:CCOupling on page 1304
MEASurement<m>:GATE:CURSor on page 1304
11.3.2 Defining the search gate
If you create a search using the "Search" toolbar icon, you can directly define the gate
by dragging a rectangle on the diagram. Otherwise, you define the gate in the "Gate"
tab of the "Search" dialog box.
1. Press the [SEARCH] key and select the "Gate" tab.
2. Select the search for which you want to define the gate.
3. Use one of the following methods:
a) Set the absolute or relative "Mode" . Enter the start and stop values of the gate
area.
b) If a zoom area has already been defined for the waveform, couple the gate
area to the zoom area by selecting the "Zoom coupling" option. If several zoom
diagrams are defined, select the zoom diagram you want to use for gating.
4. Tap "Use gate" to enable the gate.
5. Optionally, tap "Show gate" to display the gate area in the diagram.
11.4 Result presentation
Search results are displayed in a table in the "Search Results" box. In addition, a zoom
window for a selected search result can be displayed so that you can analyze the
result in more detail.
11.4.1 Result presentation settings
Access: [SEARCH] > "Result Presentation" tab
The following settings configure the layout of the result table in the "Search Results"
box and the size and position of the search zoom window. The result tables can be sor-
ted by x-position or value. You can define a maximum number of table entries.
Result presentation