Rohde & Schwarz RTE - Performing a Cursor Measurement; Showing Basic Measurement Results

Getting started
R&S
®
RTE
86User Manual 1326.1032.02 ─ 20
3.3.6 Showing basic measurement results
Using the R&S RTE you can perform and display different measurements simultane-
ously. The color of the results in the result table corresponds with the source waveform
color.
3.3.6.1 Performing a cursor measurement
1. Restore the default signal channel settings: Press the [PRESET] and [AUTOSET]
keys.
2. Tap the "Cursor" icon on the toolbar.
3. Tap the diagram in which you want to set the cursors.
Alternatively, draw a rectangle on the screen to position the cursor lines.
The cursor lines appear in the diagram and the "Cursor Results" box opens. The
measured values of the waveform at the cursor positions are displayed.
4. You can move the cursor lines in different ways:
● Touch a cursor line and drag it on the screen.
● Tap a cursor line to activate it. Turn the NAVIGATION knob to adjust the posi-
tion.
● Double-tap a cursor line. Enter the position values in the cursor setup.
Trying out the instrument