Rohde & Schwarz RTE - Using the Signal Bar

Instrument setup
R&S
®
RTE
156User Manual 1326.1032.02 ─ 20
To change the font size in dialog and result boxes
1. Press [SETUP].
2. Select the "Screen" tab.
3. To set the font size in points for text in all dialog boxes, change "Font size". Most
dialog boxes are optimized for a font size of 19 pt.
4. To set the font size in points for result boxes, change "Result dialog font size". The
default is 12 pt.
To change the transparency of dialog boxes and result boxes
The transparency of the dialog box background lets you see the waveforms behind the
box. You can configure the transparency separately for dialog boxes and result boxes.
1. Press [SETUP].
2. In the "Screen" tab, in the "Dialog box transparency" field, enter the transparency
value for dialog boxes.
For high transparency values, you can see the waveform display in the back-
ground, and possibly check the effect of the changed setting. For lower transpar-
ency values, readability in the dialog box improves.
3. In the "Result box transparency" field, enter the transparency value for result
boxes.
Alternatively, you can press the [INTENSITY] knob until the required parameter is
shown in the data input box, and then turn the knob to set the transparency.
4.4.3.4 Using the signal bar
The signal bar can hold a large number of signal and result icons. Signal icons repre-
sent the waveforms, serial buses and parallel buses, while result icons are minimized
result boxes showing measurement and search results.
To scroll the signal bar
If the signal bar contains more than four icons, not all icons are visible on the display.
► Touch one of the signal icons and move it up or down until the required icon
appears.
To switch on and off the signal bar
If you need the complete screen to see the diagrams and results, you can switch off
the signal bar completely.
► Tap the "Show signal bar" icon on the toolbar.
Display configuration