Rohde & Schwarz RTE - DC Offset Alignment

Remote control commands
R&S
®
RTE
1940User Manual 1326.1032.02 ─ 20
WGENerator<m>:MODulation:NLABsolute?
Queries the level of the noise in volts.
Suffix:
<m>
.
1..2
Return values:
<LevelAbs> Range: 0 to 12
Increment: 0.1
*RST: 0
Default unit: V
Usage: Query only
WGENerator<m>:MODulation:NLPCent <LevelPct>
Sets the noise level in percentage of the amplitude.
Suffix:
<m>
.
1..2
Parameters:
<LevelPct> Range: 0 to 100
Increment: 1
*RST: 0
Default unit: %
WGENerator<m>:MODulation:NOISe <State>
Enables the adding of noise to the waveform.
Suffix:
<m>
.
1..2
Parameters:
<State> ON | OFF
*RST: OFF
18.19.5 DC offset alignment
GENerator:ALIGnment:DC:ABORt.................................................................................1940
GENerator:ALIGnment:DC:RESult:DATE?......................................................................1941
GENerator:ALIGnment:DC:RESult:TIME?...................................................................... 1941
GENerator:ALIGnment:DC:RESult[:STATe]?................................................................... 1941
GENerator:ALIGnment:DC[:STARt]................................................................................1941
GENerator:ALIGnment:DC:ABORt
Aborts a DC offset alignment.
Waveform generator (option R&S
RTE-B6)