Rohde & Schwarz RTE - Smartgrid

Remote control commands
R&S
®
RTE
1094User Manual 1326.1032.02 ─ 20
Parameters:
<Position> Cumulative occurance value
Range: 0 to 100
Increment: 1
*RST: 50
Default unit: %
<Color> ARGB value of the color to be used for the table entry.
ARGB=<Opacity(alpha) value><red value><green value><blue
value>, in hexadecimal or decimal format.
Range: 0 to 4294967295
Increment: 1
*RST: 0
Parameters for setting and query:
<ColorTableName> Color table to be edited
<Index> Index (row number) of the new entry in the color table
Usage: Asynchronous command
DISPlay:COLor:PALette:POINt:COUNt? <PaletteName>
Queries the number of entries in the color table.
Query parameters:
<PaletteName> color table
Usage: Query only
18.7.2.3 Smartgrid
The following LAYout commands configure the SmartGrid: add and remove diagrams,
and assign signals to the diagrams. In manual operation, you configure the SmartGrid
by drag&drop.
LAYout:ADD................................................................................................................ 1094
LAYout:REMove...........................................................................................................1095
LAYout:SHOW............................................................................................................. 1096
LAYout:SIGNal:ASSign................................................................................................. 1096
LAYout:SIGNal:UNASsign.............................................................................................1096
LAYout:ADD <NodeName>, <ParentType>, <InsertBefore>, <FirstSource>,
<DiagramName>
Adds a new diagram with a waveform on the screen, in relation to an existing diagram.
Setting parameters:
<NodeName> String with the name of the existing diagram
<ParentType> HORizontal | VERTical | TAB
Position of the new diagram in relation to the existing one.
Instrument setup