Instrument setup
R&S
®
RTE
152User Manual 1326.1032.02 ─ 20
DISPlay:SIGNal:LABel:HORizontal:RELative:POSition on page 1105
DISPlay:SIGNal:LABel:VERTical:RELative:POSition on page 1105
Show labels
Enables or disables the label display.
Position mode
Defines the label position either relative to the diagram or with absolute values accord-
ing to the units of the waveform. Relative positions are fixed, whereas absolute posi-
tions move with the waveform display when the scales, the vertical position or offset, or
the reference point are changed.
The position mode applies to all labels of the selected waveform. For different wave-
forms, different position modes can be selected.
"Relative"
Sets a fixed position in percent of the screen counting from the upper
left corner.
"Absolute"
Sets the position in time and voltage values, or in other units depend-
ing on the waveform character.
Remote command:
DISPlay:SIGNal:LABel:POSMode on page 1104
4.4.2.5 Performance
Access: "Display" menu > "Show Performance"
The "Performance" result box shows information on the current acquisition perfor-
mance values of the R&S RTE.
The instrument groups acquired waveforms together in a frame, and displays the frame
content. The maximum number of frames displayed per second is about 30. The cur-
rent number of frames per second is indicated as reciprocal "Time per frame". If the
time scale decreases, and thus the number of acquisitions per second also decreases,
the number of acquisitions per frame can drop to 1.
4.4.2.6 Clear results
"Display" menu > "Clear all"
"Clear all" resets all results in all measurement result boxes including long-term mea-
surement and statistic results, and deletes all waveforms and the history.
If you need this function frequently, you can add the corresponding icon to the toolbar,
see Chapter 3.4.7.2, "Configuring the toolbar", on page 119.
Display configuration
To Next Page
Loading...
