Rohde & Schwarz RTE - Decode Results

Remote control commands
R&S
®
RTE
1538User Manual 1326.1032.02 ─ 20
18.17.7.3 Decode results
To load and acivate a label list, use:
●
BUS<m>:NEWList on page 1422
●
BUS<m>:SYMBols on page 1423
BUS<m>:LIN:FCOunt?................................................................................................. 1538
BUS<m>:LIN:FRAMe<n>:STATus?................................................................................1538
BUS<m>:LIN:FRAMe<n>:STARt?..................................................................................1539
BUS<m>:LIN:FRAMe<n>:STOP?.................................................................................. 1539
BUS<m>:LIN:FRAMe<n>:SDATa?................................................................................. 1539
BUS<m>:LIN:FRAMe<n>:SDEXport?.............................................................................1540
BUS<m>:LIN:FRAMe<n>:SYMBol?............................................................................... 1540
BUS<m>:LIN:FRAMe<n>:VERSion?..............................................................................1540
BUS<m>:LIN:FRAMe<n>:DATA?...................................................................................1541
BUS<m>:LIN:FRAMe<n>:IDSTate?............................................................................... 1541
BUS<m>:LIN:FRAMe<n>:IDValue?................................................................................1541
BUS<m>:LIN:FRAMe<n>:IDPValue?..............................................................................1542
BUS<m>:LIN:FRAMe<n>:SYSTate?.............................................................................. 1542
BUS<m>:LIN:FRAMe<n>:CSSTate?.............................................................................. 1543
BUS<m>:LIN:FRAMe<n>:CSValue?.............................................................................. 1543
BUS<m>:LIN:FRAMe<n>:BITRate?............................................................................... 1543
BUS<m>:LIN:FRAMe<n>:BYTE<o>:STATe?...................................................................1544
BUS<m>:LIN:FRAMe<n>:BYTE<o>:VALue?...................................................................1544
BUS<m>:LIN:FCOunt?
Returns the number of decoded frames.
Suffix:
<m>
.
1..4
Selects the serial bus.
Return values:
<Count> Total number of decoded frames.
Usage: Query only
BUS<m>:LIN:FRAMe<n>:STATus?
Returns the overall state of the selected frame.
Suffix:
<m>
.
1..4
Selects the serial bus.
<n> *
Selects the frame.
Return values:
<FrameState> OK | UART | CHCKsum | VERS | LENer | SPERror | PRERror |
SYERror | WAKeup | CPERror | INSufficient | INComplete
Protocols