Measurements
R&S
®
RTE
340User Manual 1326.1032.02 ─ 20
To clear the measurement results
1. On the "Display" menu, tap "Clear all".
2. To restart measurement statistics, without deleting other results, select "Reset" on
the "Result Analysis" tab.
The results in the selected measurement result box are cleared and written anew.
8.2.2.3 Display settings for results
Display settings are specific for each measurement.
Access: "Meas" menu > "Gate/Display"
Gate settings are described in
Chapter 8.2.3.2, "Gate settings for measurements",
on page 341.
Display result lines
Result lines mark the samples in the waveform that are used to obtain the measure-
ment result. For example, maximum, minimum, high and low values, and mean are
merked by horizontal lines; start and end are marked by vertical lines.
Remote command:
MEASurement<m>:DISPlay:RESults on page 1287
Display reference levels
Displays the reference levels used for the measurement in the diagram.
Remote command:
MEASurement<m>:DISPlay:LEVels on page 1287
Automatic measurements
To Next Page
Loading...
