Rohde & Schwarz RTE - Signal Colors; Persistence

Remote control commands
R&S
®
RTE
1090User Manual 1326.1032.02 ─ 20
● Diagram layout....................................................................................................1097
● Waveform labels..................................................................................................1101
● Clear results........................................................................................................ 1105
18.7.2.1 Signal colors / persistence
DISPlay:PERSistence[:STATe].......................................................................................1090
DISPlay:PERSistence:INFinite.......................................................................................1090
DISPlay:PERSistence:TIME..........................................................................................1090
DISPlay:PERSistence:RESet........................................................................................ 1091
DISPlay:INTensity........................................................................................................ 1091
DISPlay:DIAGram:STYLe............................................................................................. 1091
DISPlay:COLor:SIGNal<m>:COLor................................................................................1091
DISPlay:COLor:SIGNal<m>:ASSign...............................................................................1092
DISPlay:COLor:SIGNal<m>:USE...................................................................................1092
DISPlay:PERSistence[:STATe] <State>
If enabled, each new data point in the diagram area remains on the screen for the
duration defined using DISPlay:PERSistence:TIME, or as long as DISPlay:
PERSistence:INFinite is enabled.
If disabled, the signal value is only displayed as long as it actually occurs.
Parameters:
<State> ON | OFF
*RST: ON
Usage: Asynchronous command
DISPlay:PERSistence:INFinite <State>
If persistence is enabled (DISPlay:PERSistence[:STATe]), each new data point in
the diagram area remains on the screen infinitely until this command is set to "OFF".
Parameters:
<State> ON | OFF
*RST: OFF
Usage: Asynchronous command
DISPlay:PERSistence:TIME <Time>
If persistence is enabled (DISPlay:PERSistence[:STATe]), each new data point in
the diagram area remains on the screen for the duration defined here.
Parameters:
<Time> Range: 0.05 to 50
Increment: 0.05
*RST: 0.05
Default unit: s
Instrument setup