Data and file management
R&S
®
RTE
511User Manual 1326.1032.02 ─ 20
For details on save/recall instrument settings and associated remote commands, see
Chapter 12.1.1, "Savesets", on page 471.
To save a user-defined preset
1. Press the "File" menu > "Preset setup".
2. Enter a name for the preset file. Select the file format.
3. Tap Save.
Note: If you want to store the file in another directory than the default one, select
"Save As". See also: Chapter 12.7, "File selection dialog", on page 511
To restore the instrument settings to user-defined default values
1. Press the "File" menu > "Preset setup".
2. Tap "Open" and select the preset file that contains the required settings.
The instrument settings are restored to values that are stored in the file.
3. To use these settings as preset values, select "Enable user-defined preset".
4. Press the [PRESET] key.
To restore all settings to the factory defaults
1. Press the "File" menu > "Preset setup".
2. Tap the "Factory defaults" button.
All settings on the R&S RTE are reset to their factory-defined values. As long as no
user-defined preset file is loaded and "Enable user defined preset " is disabled, the
[PRESET] key also resets the instrument settings to factory defaults.
12.7 File selection dialog
The file selection dialog provides a file explorer from which you can select a file to load
or to save data to. You can also manage your files in this dialog.
File selection dialog
To Next Page
Loading...
