Rohde & Schwarz RTE - Noise Setup

Remote control commands
R&S
®
RTE
1939User Manual 1326.1032.02 ─ 20
Parameters:
<Inversion> ON | OFF
*RST: OFF
WGENerator<m>:VOLTage:LOW <Low>
Sets the low signal level of the output waveform.
Suffix:
<m>
.
1..2
Parameters:
<Low> Range: -6 to 5.99
Increment: 0.1
*RST: -0.5
Default unit: V
WGENerator<m>:VOLTage:OFFSet <Offset>
Sets a voltage offset.
Suffix:
<m>
.
1..2
Parameters:
<Offset> Range: -5.995 to 5.995
Increment: 0.1
*RST: 0
Default unit: V
18.19.4 Noise setup
WGENerator<m>:MODulation:NDCLevel........................................................................1939
WGENerator<m>:MODulation:NLABsolute?................................................................... 1940
WGENerator<m>:MODulation:NLPCent......................................................................... 1940
WGENerator<m>:MODulation:NOISe.............................................................................1940
WGENerator<m>:MODulation:NDCLevel <LevelDC>
Sets the DC noise level.
Suffix:
<m>
.
1..2
Parameters:
<LevelDC> Range: 0 to 12
Increment: 0.1
*RST: 0.01
Default unit: V
Waveform generator (option R&S RTE-B6)