Protocol analysis
R&S
®
RTE
864User Manual 1326.1032.02 ─ 20
●
Time Code consisting of an ESC followed by a single data character
Figure 13-110: SpaceWire control codes
13.18.2 SpaceWire configuration
13.18.2.1 SpaceWire configuration settings
Access: [PROTOCOL] > "Decode" tab > "Protocol = SpaceWire"
Make sure that the tab of the correct serial bus is selected.
See also: Chapter 13.1.1, "Decode - general settings", on page 514.
SpaceWire (option R&S
RTE-K65)
To Next Page
Loading...
