Rohde & Schwarz RTE - Decode Results

Remote control commands
R&S
®
RTE
1619User Manual 1326.1032.02 ─ 20
TRIGger<m>:MILStd:STATus:SUBSystem <SubsystemFlag>
Triggers on the state of the subsystem flag bit of the status word if TRIGger<m>:
MILStd:TYPE is set to STATword.
Parameters:
<SubsystemFlag> ONE | ZERO | DC
*RST: DC
TRIGger<m>:MILStd:STATus:TERMinal <TerminalFlag>
Triggers on the state of theterminal flag bit of the status word if TRIGger<m>:
MILStd:TYPE is set to STATword.
Parameters:
<TerminalFlag> ONE | ZERO | DC
*RST: DC
TRIGger<m>:MILStd:TPSPecifier
<TypeSpecifier>
Sets the sync impulse/ word type to be triggered on.
Parameters:
<TypeSpecifier> CSTatus | DATA | ALL
CSTatus: command/status word
*RST: ALL
18.17.10.3 Decode results
To load and acivate a label list, use:
●
BUS<m>:NEWList on page 1422
●
BUS<m>:SYMBols on page 1423
BUS<m>:MILStd:WCOunt?...........................................................................................1619
BUS<m>:MILStd:WORD<n>:DATA?.............................................................................. 1620
BUS<m>:MILStd:WORD<n>:INFO?...............................................................................1620
BUS<m>:MILStd:WORD<n>:RTADdress?...................................................................... 1620
BUS<m>:MILStd:WORD<n>:STARt?............................................................................. 1621
BUS<m>:MILStd:WORD<n>:STATus?........................................................................... 1621
BUS<m>:MILStd:WORD<n>:STOP?..............................................................................1622
BUS<m>:MILStd:WORD<n>:SYMBol?...........................................................................1622
BUS<m>:MILStd:WORD<n>:TYPE?..............................................................................1622
BUS<m>:MILStd:WCOunt?
Returns the number of decoded words.
Suffix:
<m>
.
1..4
Protocols