Remote control commands
R&S
®
RTE
1224User Manual 1326.1032.02 ─ 20
REFCurve<m>:RESCale:HORizontal:OFFSet <Offset>
Moves the waveform horizontally. Positive values shift the waveform to the right, nega-
tive values shift it to the left.
Suffix:
<m>
.
1..4
Reference waveform
Parameters:
<Offset> Range: -100E+24 to 100E+24
Increment: 0.01
*RST: 0
Default unit: s
Usage: Asynchronous command
18.10.2.3 Waveform data export
Commands for saving waveform data to file are described in Chapter 18.16.5, "Wave-
form data export to file", on page 1399.Commands for reference waveforms are listed
below.
REFCurve<m>:DATA:STYPe?.......................................................................................1224
REFCurve<m>:DATA:HEADer?.....................................................................................1224
REFCurve<m>:DATA[:VALues]?....................................................................................1225
REFCurve<m>:DATA:STYPe?
Returns the signal type of the source of the reference waveform.
Suffix:
<m>
.
1..4
Reference waveform
Return values:
<SignalType> SOUR | SPEC | CORR | NONE
SOURce = normal signal
SPECtrum = FFT spectrum, specific math signal
CORRelation = correlated signal, specific math signal
NONE = undefined
Usage: Query only
REFCurve<m>:DATA:HEADer?
Returns information on the reference waveform.
Waveform analysis
To Next Page
Loading...
