Getting started
R&S
®
RTE
124User Manual 1326.1032.02 ─ 20
Save Waveform
Exports the waveform data to file using the settings defined in [FILE] > "Waveforms /
Results" > "Waveforms". The filename is created according to the autonaming pattern.
Tap the icon and then tap the waveform to be exported. If you tap the display back-
ground, the selected waveform is exported, or a multichannel export is performed if
configured.
Spectrogram (option R&S RTE-K18)
Starts an FFT and the spectrogram. The FFT trace and the spectrogram are shown in
separate diagrams.
Tap the icon and then tap diagram with the waveform to be transformed. The diagrams
are created from the selected waveform.
3.4.8 Displaying results
The results of automatic and cursor measurements, mask tests, and searches are dis-
played immediately in a result box.
There are several places to display the results:
●
In a floating result box in front of the diagrams, which you can move on the display
●
In a minimized view (result icon) on the signal bar
●
In a separate tab
●
In a docked tab below the diagram (available only for automatic and cursor mea-
surements)
The default position and the font size can be adjusted.
To arrange a result box on the display
► Touch the title of the result box and drag the box on the screen. If the results are
docked, touch a result line and drag it. The SmartGrid indicates where the result
box will be placed.
● If you drop the box on one of the buttons, the results are shown in a separate
tab besides, above, or below the diagram.
● If you drop the box on the signal bar, a result icon is created.
● If you drop the box somewhere else, a floating result box is created.
Operating the instrument
To Next Page
Loading...
