Protocol analysis
R&S
®
RTE
859User Manual 1326.1032.02 ─ 20
●
BUS<m>:USBPd:RESult:FRAMe<n>:FLD<o>:TYPE? on page 1842
●
BUS<m>:USBPd:RESult:FRAMe<n>:FLD<o>:VAL? on page 1842
13.17.5 Search on decoded USBPD data
Using the search functionality, you can find various events in the decoded data. You
can find the same events that you can trigger on, and even many more, since several
event types can also be combined.
Before you can start the search, you have to configure the bus correctly and acquire
decoded data.
To search on decoded data, set the search source to "SerBus" for the configured proto-
col.
For general information on how to handle the search functionality, see Chapter 11,
"Search functions", on page 445.
If you need information on how to get started with searching USBPD data, see Chap-
ter 13.17.5.3, "Searching USBPD data", on page 862. Otherwise proceed with the
USBPD search setup.
13.17.5.1 USBPD search setup
Access: [SEARCH] > "Setup" tab
Search
In the "Search" dialog to define the frame type in which data is to be searched.
USBPD (option R&S RTE-K63)
To Next Page
Loading...
