Getting started
R&S
®
RTE
65User Manual 1326.1032.02 ─ 20
The maximum input voltage is 40 V peak at 100 kΩ input impedance. The maximum
input frequency for a signal with the minimum input voltage swing of 500 mV (V
pp
) is
400 MHz. For detailed specifications, refer to the data sheet.
Waveform generator option R&S RTE-B6
The waveform generator generates various function and arbitrary waveforms, sweeps,
and parallel patterns. For detailed specifications, refer to the data sheet.
The option can be installed in the option slot at the rear panel.
The module provides the following connectors:
[Gen1, Gen2]
BNC connectors
[PattGen]
Connector for the pattern generator
GBIP option R&S RTE-B10
The GBIP option provides a GBIP interface and connector for remote control. For
detailed specifications, refer to the data sheet.
3.2.3 Keys and controls
3.2.3.1 POWER key
The [POWER] key is located on the lower left corner of the front panel. It starts up and
shuts down the instrument's software.
The light of the key shows the instrument state:
●
Standby, the main power switch is on, the software is shut down: orange.
●
The instrument is ready for operation: green.
See also: Chapter 3.1.7, "Switching on or off", on page 57.
3.2.3.2 SETUP controls
SETUP keys set the instrument to a defined state, change basic settings, and provide
saving and help functions. The intensity rotary knob adjusts the display contrast for
several display elements.
[AUTOSET]
The instrument analyzes the enabled channel signals, and adjusts appropriate horizon-
tal, vertical, and trigger settings to display stable waveforms.
[PRESET]
Resets the instrument to a default state. All measurements, mask tests, zoom, and
most individual settings are deleted, and all channels except for channel 1 are dis-
abled. You can define preset configurations and save them to a file. The [PRESET] key
can be configured to set either factory defaults or a user-defined preset configuration.
Instrument tour
To Next Page
Loading...
