Rohde & Schwarz RTE - General Search Settings

Remote control commands
R&S
®
RTE
1352User Manual 1326.1032.02 ─ 20
18.15.1 General search settings
SEARch:ADD.............................................................................................................. 1352
SEARch:CLEar............................................................................................................1352
SEARch:REMove.........................................................................................................1352
SEARch:SOURce........................................................................................................ 1352
SEARch:ONLine.......................................................................................................... 1353
SEARch:ALL............................................................................................................... 1353
SEARch:ADD <SearchName>
Creates a new search definition with the specified name.
Setting parameters:
<SearchName> String with the name of the search
Example: See Chapter 18.3.4.1, "Searching for a pulse of specified width",
on page 1060
Usage: Setting only
Asynchronous command
SEARch:CLEar <SearchName>
Clears the search results once to start a new search.
Setting parameters:
<SearchName> Search definition
Usage: Setting only
Asynchronous command
SEARch:REMove <Key>
Deletes the specified search definition.
Setting parameters:
<Key> String with the name of the search
Usage: Setting only
Asynchronous command
SEARch:SOURce <SearchName>,<Source>
SEARch:SOURce? <SearchName>
Defines the source on which the search conditions are applied. The source can be any
analog or digital channel, math or reference waveform as well as a serial bus config-
ured for a supported protocol.
Search