Rohde & Schwarz RTE - Calibration Results; Probe Adapter R&S RT-Z2 T; Probe Adapter R&SRT-Z2 T

Acquisition and waveform setup
R&S
®
RTE
216User Manual 1326.1032.02 ─ 20
●
PROBe<m>:ID:PARTnumber? on page 1141
●
PROBe<m>:ID:SRNumber? on page 1142
●
PROBe<m>:SETup:CAPacitance? on page 1142
●
PROBe<m>:SETup:IMPedance? on page 1142
●
TRPRobe:ID:SWVersion? on page 1141
●
TRPRobe:ID:PRDate? on page 1141
●
TRPRobe:ID:PARTnumber? on page 1141
●
TRPRobe:ID:SRNumber? on page 1142
●
TRPRobe:SETup:CAPacitance? on page 1142
●
TRPRobe:SETup:IMPedance? on page 1142
5.5.10 Calibration results
The "Calibration Results" tab provides the calibration data stored in the probe for all
R&S probes connected to an input channel.
5.5.11 Probe adapter R&S RT‑Z2T
Using the R&S RT‑Z2T probe interface adapter, you can connect selected Tektronix
active probes with TekProbe BNC
TM
level II interface.
1. Connect the R&S RT‑Z2T adapter to the channel input.
2. Connect the probe to the adapter.
The instrument identifies the adapter. The R&S RTE lists the supported Tektronix
probes as "Predefined probe".
3. Select "Vertical" menu > "Probe Setup".
The dialog shows that the R&S RT‑Z2T probe interface adapter is connected.
Probes