Rohde & Schwarz RTE - Settings for Histogram Measurement

Measurements
R&S
®
RTE
375User Manual 1326.1032.02 ─ 20
Remote command:
LAYout:HISTogram:HORZ:MODE on page 1279
LAYout:HISTogram:VERTical:MODE on page 1281
Horizontal start/stop value
Defines the horizontal value range of the histogram.
Remote command:
LAYout:HISTogram:HORZ:ABSolute:STARt on page 1280
LAYout:HISTogram:HORZ:ABSolute:STOP on page 1280
LAYout:HISTogram:HORZ:RELative:STARt on page 1280
LAYout:HISTogram:HORZ:RELative:STOP on page 1280
Vertical start/stop value
Defines the vertical value range of the histogram.
Remote command:
LAYout:HISTogram:VERTical:ABSolute:STARt on page 1281
LAYout:HISTogram:VERTical:ABSolute:STOP on page 1281
LAYout:HISTogram:VERTical:RELative:STARt on page 1282
LAYout:HISTogram:VERTical:RELative:STOP on page 1282
8.2.8.5 Settings for histogram measurement
Access: "Meas" menu > "Setup" > "Hist" category
You can perform measurements on histograms. Before, you have to define a histo-
gram, see Chapter 8.2.8.3, "Creating histograms", on page 372.
The measurement parameters are common for all histogram measurement types.
Histogram
Selects the histogram on which the measurement is based. Before, you have to define
a histogram, see Chapter 8.2.8.3, "Creating histograms", on page 372.
Remote command:
MEASurement<m>:HISTogram:SELect on page 1284
Probability domain marker, Reference
Defines the marker reference in the probability domain.
"Peak"
The y-value with the maximum sample value in the histogram
Automatic measurements