Measurements
R&S
®
RTE
374User Manual 1326.1032.02 ─ 20
Enable
Enables or disables the histogram evaluation and display. The histogram settings are
kept until the histogram is deleted.
Source
Defines the source of the histogram. Any analog channel waveform, math or reference
waveform can be selected. Also measurements can serve as histogram source. In this
case, the density distribution of the results of the main measurement is displayed.
Remote command:
LAYout:HISTogram:SOURce on page 1278
Diagram size
Defines the size of the histogram in percent of the diagram.
Mode
Defines the type of histogram.
"Vertical"
Amplitude histogram (horizontal bars across amplitude)
"Horizontal"
Time histogram (vertical bars over time). For spectrum waveforms,
horizontal histograms over spectrum are not available.
Remote command:
LAYout:HISTogram:MODE on page 1279
Reset now
Resets the values to begin a new histogram.
Remote command:
LAYout:HISTogram:RESet on page 1282
Range definition mode (Absolute/Relative)
Defines whether the value range limits are entered as absolute or relative values.
Automatic measurements
To Next Page
Loading...
