Search functions
R&S
®
RTE
467User Manual 1326.1032.02 ─ 20
This stops a running search and a running acquisition.
The zoom area is indicated in the diagram that displays the source waveform of the
search. The zoom window is displayed for the first result that was found.
2. If you need to adjust the search zoom area, you can drag the area or their edges
on the screen. You can also enter the limits of the search zoom window in the
"Search > Results Presentation" tab.
Be aware, that the zoom window size is valid for all results of a search definition. If
you change the settings drastically for one result, they may not be correct for the
next search result you switch to.
See also:
● Chapter 7.1.3, "Zooming for details", on page 284
● "Navigating search results" on page 447
11.5 Noise reject
Noise rejection for searches is similar to noise rejection for triggers. You can reject
noise by setting a hysteresis to avoid finding events caused by noise oscillation around
the trigger level.
11.5.1 Noise reject settings
Access: [SEARCH] > "Noise Reject" tab
You can select the hysteresis mode and value for each analog and digital input chan-
nel, math and reference waveform.
The noise reject settings are similar to those for triggers, see also Chapter 6.5, "Noise
Reject", on page 265.
Noise reject
If enabled, the hysteresis is considered for the search.
Noise reject
To Next Page
Loading...
