Rohde & Schwarz RTE - Actions on Limit Check Results

Measurements
R&S
®
RTE
394User Manual 1326.1032.02 ─ 20
Limits are stricter than the margins for the value check. Thus, the margins must be
within the valid range. If necessary, the limit and margin values are adapted according
to the selected valid range.
The settings are only visible if "Limit check" is enabled.
Remote command:
MEASurement<m>:AMPTime:LCHeck<n>:LOWer:LIMit on page 1265
MEASurement<m>:AMPTime:LCHeck<n>:LOWer:MARGin on page 1266
MEASurement<m>:AMPTime:LCHeck<n>:UPPer:LIMit on page 1265
MEASurement<m>:AMPTime:LCHeck<n>:UPPer:MARGin on page 1266
MEASurement<m>:AMPTime:LCHeck<n>:VALid on page 1265
MEASurement<m>:EYEJitter:LCHeck<n>:LOWer:LIMit on page 1268
MEASurement<m>:EYEJitter:LCHeck<n>:LOWer:MARGin on page 1269
MEASurement<m>:EYEJitter:LCHeck<n>:UPPer:LIMit on page 1268
MEASurement<m>:EYEJitter:LCHeck<n>:UPPer:MARGin on page 1269
MEASurement<m>:EYEJitter:LCHeck<n>:VALid on page 1268
MEASurement<m>:HISTogram:LCHeck<n>:LOWer:LIMit on page 1286
MEASurement<m>:HISTogram:LCHeck<n>:LOWer:MARGin on page 1286
MEASurement<m>:HISTogram:LCHeck<n>:UPPer:LIMit on page 1286
MEASurement<m>:HISTogram:LCHeck<n>:UPPer:MARGin on page 1286
MEASurement<m>:HISTogram:LCHeck<n>:VALid on page 1285
MEASurement<m>:SPECtrum:LCHeck<n>:LOWer:LIMit on page 1276
MEASurement<m>:SPECtrum:LCHeck<n>:LOWer:MARGin on page 1277
MEASurement<m>:SPECtrum:LCHeck<n>:UPPer:LIMit on page 1276
MEASurement<m>:SPECtrum:LCHeck<n>:UPPer:MARGin on page 1277
MEASurement<m>:SPECtrum:LCHeck<n>:VALid on page 1276
8.2.11.3 Actions on limit check results
On the "Limit Check" tab, you also define what happens when the limits and margins
are exceeded. Limit checking must be enabled.
Actions are initiated by all measurements and all results measured on one acquisition.
Note that the violation actions do not distinguish between a margin violation and a limit
violation. However, different icons are displayed in the result box.
For each action, you can define the event on which the action is initiated:
●
On violation
The action is initiated when the limits or margins are exceeded during the mea-
surement.
●
On successful completion
The action is initiated when a defined number of acquisitions has been captured,
and the limits or margins were not exceeded.
Independent of these actions, an icon is displayed in the result box, see Chapter 8.2.2,
"Measurement results", on page 337.
Beep
Generates a beep sound.
Automatic measurements